Elliptical Troubleshooting Guide
|Console has no power.||DC adapter is not plugged
into wall outlet?
|Plug DC adapter into wall outlet.|
|DC adapter is not plugged into the Elliptical?||Plug DC adapter into the Elliptical’s power socket|
|Console cable is not connected?||Verify that the console cable is connected properly|
|The console is faulty?||Call service|
Speed shows 0
|Computer isn’t receiving a
signal from the sensor?
|Check that the sensor magnet is correctly
fitted and passes in front of the sensor.
|Check that the gap between the sensor
and the magnet is 3mm or less.
|Check that all the computer plugs and sockets
are correctly and firmly connected.
|The sensor is faulty?||If all above checks are O.K., then replace sensor|
|The computer is faulty?||Call service.|
|No HR signal
incorrect HR signal
|Computer is receiving a faint or
intermittent pulse signal.
|Check that the pulse plugs firmly
inserted into the sockets.
|Check to make sure that the batteries in
the chest strap are installed correctly.
|Replace the chest strap batteries.|
|Check to see if the receiver is properly installed.|
|Check to see if the chest strap is being properly worn by the user – if skin is extremely dry, then moisten contact points on chest with water and try again.|
|If the problem still exists then call
|Noise from motor||Symptoms include an unusually loud noise coming from the motor,
which means the gears are
not meshing correctly.
|Try reversing the resistance and try again.
If this fails, then replace the motor.